Sapphire RX 480 Nitro+ 8/4GB: The Rise of Polaris - Bits and Chips Skin ADV
Text Size

- PRESS RELEASE-

July 22nd, 2016 – SAPPHIRE Technology opens a new chapter in the SAPPHIRE NITRO Gaming Series with the introduction of the SAPPHIRE NITRO+ Radeon™ RX 480. Adding innovative technologies and user-facing features to the efficient Polaris foundations, SAPPHIRE NITRO+ puts gamers in a front-row seat for the next-gen graphics era.

The SAPPHIRE NITRO+ Radeon™ RX 480 Gaming Series is designed for high-quality 1440p gaming. It features a 4th generation Graphics Core Next chip with an improved geometry engine, increased caches and native asynchronous shaders. The NITRO+ RX 480 8GB version comes with 2304 GCN-based stream processors that run with a factory-overclock boost clock of 1342 MHz. The model comes with a full 8 GB GDDR5 memory clocked at 2000 MHz on a 256-bit interface. The NITRO+ RX 480 4GB version delivers a factory-overclock boost clock of 1306 MHz with 4GB of GDDR5 memory clocked at 1750 MHz.

Powerful specs and VR-specific architectural optimizations, as well as the use of AMD LiquidVR™ technology, provide a premium Virtual Reality experience (scoring over 6.3 in a Steam VR Performance test), previously available only on significantly more expensive cards. The SAPPHIRE NITRO+ version is even more VR-friendly, with two HDMI ports: allowing the user to have both an HD monitor and cutting-edge VR headset running at the same time.

rx480-nitro

Dual-X Cooling Perfected

One of the most innovative parts of SAPPHIRE’s first custom-designed Polaris card are the fans. The SAPPHIRE NITRO+ Radeon™ RX 480 features improved Dual-X cooling with two 95 mm dual-ball bearing fans that have an 85% longer lifespan compared to fans with sleeve bearings. The improvements to the fan blades means the solution is up to 10% quieter than the previous generation.

rx480-nitro-2

Serving the Fans

SAPPHIRE has also upped the stakes with its new Fan Check, which allows users to check the cooler’s status via the upcoming SAPPHIRE TriXX 3.0 and immediately contact customer support in case of problems. To resolve a specific fan issue, Fan Service provides a quick and easy solution. If there’s a fan issue detected, the user doesn’t need to return the entire card – SAPPHIRE or its channel partners will send out a replacement fan directly to the customer.

On top of that, SAPPHIRE NITRO+ Radeon™ RX 480 fans use the Quick Connect system. This means they’re easy to remove, clean, and replace, with just one screw holding them securely in place – without the need to disassemble the shroud or other parts of the card.

Improved Intelligent Fan Control III system turns off the fans completely in a low load situation and, with the help of the additional NITRO CoolTech, the fan starts precisely at 52 degrees Celsius to smartly balance performance against fan noise.

Making it Glow

Just as important as the performance nowadays are the aesthetics of the hardware inside a user’s PC. Equipped with new NITRO Glow, the NITRO+ Radeon™ RX 480 comes with a tasteful shroud design augmented by RGB LEDs. The user can customize the colours of the LEDs via software using the SAPPHIRE TriXX 3.0 utility or through hardware by pressing the red button on the back of the card. The system contains a set of five different modes, including Fan Speed Mode, GPU Temperature Mode or the colourful rainbow mode. The LEDs can also be turned off, if the user prefers so.

rx480-nitro-3


Power to the Power User

For overclocking enthusiasts, SAPPHIRE has added extra features to help get even more out of the new NITRO+ card. The NITRO Boost (Dual Bios) switch increases the boost clock and power limit for higher performance.The SAPPHIRE NITRO+ Radeon™ RX 480 also comes with an 8-pin power connector for additional powering: ideal for OC. SAPPHIRE's unique Black Diamond Chokes used in the new model are now Mark 4, reducing the coil temperatures by another 15% over the previous version.

Model SAPPHIRE NITRO+ Radeon RX 480
Graphics processor Polaris 10 XT
Manufacturing process FinFET 14 nm
Memory 8 GB GDDR5 256-bit / 4GB GDDR5 256-bit
Stream processors 2304
Compute units 36
Engine clock 1342 MHz (8GB) / 1306 MHz (4GB)
Memory clock 2000 MHz (8GB) /1750 MHz (4GB)
Cooling system Dual-X, two 95 mm dual-ball bearing fans
Outputs 2x DisplayPort 1.4 ready, 2x HDMI 2.0b
Interface PCI-Express 3.0
Special features
  • Dual Firmware (UEFI BIOS)
  • Fan Check
  • Quick Connect
  • Intelligent Fan Control III
  • NITRO CoolTech
  • NITRO Glow
  • NITRO Boost
Technologies

DirectX 12, Vulkan 1.0, OpenGL 4.5, OpenCL 2.0, AMD FreeSync,

AMD CrossFire XDMA (bridgeless), AMD Eyefinity, AMD LiquidVR

 

OkNotizie
Michele Carasia
Autore: Michele Carasia
Esperto in:
Schede video, CPU, overclock, videogames
E' stato newser e reviewer per importanti portali italiani occupandosi in particolare di schede video e processori. Appassionato anche di overclock e videogames.
Notizie postate da Michele CarasiaArticoli postati da Michele Carasia
1947
news
68
articoli
     Questo indirizzo email è protetto dagli spambots. E' necessario abilitare JavaScript per vederlo.